Setting DMX on a ColorSource Fixture

Turn on the power to the fixture.

1. Access the DMX address:

   • Press any button to wake up the display. 
   • The display will show the current DMX address. 

2. Change the DMX address (if needed):

   • Press and hold the "Mode" button for 3 seconds to access the DMX control mode menu. 
   • Use the "Up" or "Down" buttons to select the desired DMX control mode (e.g., 5ch, dir, 1ch, rgb). 
   • Press the "Mode" button to confirm and save your selection. 

3. Set the starting address:

   • Once the DMX control mode is selected, you can change the DMX starting address by pressing the "Up" or "Down" buttons to adjust the numbers on the display. 
   • Press the "Mode" button to confirm and save the new DMX starting address.