Skip to main content

 

Electronic Theatre Controls Inc

SineWave SWD20 Module Switching LED Loads

  1. Last updated
  2. Save as PDF

Considerations When Switching Loads with an SWD20

The SWD20 can be setup to switch LED loads on/off by putting the module into switched mode within the CEM+. However, be sure that the connected LED load does not exceed 200A of inrush current; otherwise the module will turn its output off.

  1. Back to top
  • Was this article helpful?

Recommended articles

  1. Article type
    Topic
  2. Tags
    1. sinewave switched LED overcurrent