Skip to main content
Electronic Theatre Controls Inc

Update Failed Error on E-PCP on ERP Feedthrough

  1. Last updated
  2. Save as PDF

Issue

I am loading new firmware onto my ETC relay panel processor and am getting "Update Failed: One or more steps in the update process failed." on the screen. When I view details, it shows all portions of the update failed.

Rev 1 update fail image.jpg

Explanation

This message appears if you are trying to load v4.0.0 or higher to an original revision processor.  These original processors are not capable of loading firmware above v3.x.  Firmware v4.0.0 or higher can only be loaded on the the Mk2 processor.

 

  1. Back to top
  • Was this article helpful?

Recommended articles

  1. Article type
    Reference
  2. Tags
    This page has no tags.