Skip to main content
Electronic Theatre Controls Inc

Expression 2, 2x and 3 Jumper_DIP Switch Guide

 clipboard_e11f188b879c1017fb385d7137f201d83.png

Important-Icon.png

The information in this post is provided to assist in troubleshooting. Perform work at your own risk. ENSURE ANY POWER FROM DEVICES HAS BEEN DISCONNECTED BEFORE SERVICING ANY EQUIPMENT. If you do not feel comfortable performing the work, please contact us or your local service center. Be aware that ETC and its Affiliates are not responsible for any damage or injury caused by service of our products by anyone other than us or our authorized service providers, and such damage is excluded from the product’s warranty.

PRE-UNIVERSAL EXPRESSION 2X LINE CPU

Note that DIP Switches are mounted upside-down as you face them - Off = away from you, On = toward you

Switch S4 (near LEDs in upper right corner of CPU)
DIP FUNCTION POSITION ACTION
1 Factory Off Should always be off
2, 3 Start Up Mode Off Off
On On
On Off
Off On
Network Off
Network on/One console
Network on/FTB Console A
Network on/FTB Console B
4 SMPTE Off
On
SMPTE disabled
SMPTE enabled
5-8 Factory All Off Should always be off

 

Switches S1 and S2 (on left side of CPU)
ETCNet wire determination
S1 S2 ACTION
On Off Twisted Pair (UTP) and ThickNet active
Off On ThinNet active

NOTE: Impression 2 CPU only supports Twisted Pair (UTP) cable type.

PRE-UNIVERSAL FACEPANEL

Expression 2x Consoles

Jumper J20 (lower right side of PCB) - MIDI Settings
PIN ACTION
1 Enable MIDI Out
2 Enable MIDI Out as MIDI Thru

Insight 2x Consoles

Jumper J7 (lower right of center on PCB) - MIDI Settings
PIN ACTION
A Enable MIDI Out
B Enable MIDI Out as MIDI Thru

UNIVERSAL EXPRESSION 2X/3 LINE CPU

Switch S1 (back of console, near ETCNet connectors)
DIP FUNCTION POSITION ACTION
1 Factory Up Should always be off
2, 3 Start Up Mode Up Up
Down Down
Down Up
Up Down
Network Off
Network on/One console
Network on/FTB Console A
Network on/FTB Console B
4-6 Factory Up Should always be up
7 ETCNet Wire Up
Down
ThinNet
Twisted Pair (UTP)
8 UTP Polarity Up
Down
Normal
Pairs Swapped

NOTE: Impression 2 CPU only supports Twisted Pair (UTP) cable type.

UNIVERSAL EXPRESSION 2X/3 FACEPANEL

Expression 2x Consoles

Jumper J5 (lower right side of PCB) - MIDI Settings
PIN ACTION
1 Enable MIDI Out
2 Enable MIDI Out as MIDI Thru

Insight 2x Consoles

Jumper J8 (lower right side of PCB) - MIDI Settings
PIN ACTION
A Enable MIDI Out
B Enable MIDI Out as MIDI Thru
  • Was this article helpful?