Factory Data Reset on ETCPad

Factory rest for software versions lower than 3.0.0

ETCPads that are running software below 3.0.0 can be restored to factory settings via the settings menu. 

This is to reset to ETC Factory defaults, not to Android factory defaults. 

If you navigate to Settings>Reset>Factory Data Reset>Reset Tablet the ETCPad will be restored to the state it was in when purchased from ETC.

Android factory reset for version 3.0.0 and up

THIS WILL WIPE ALL SAVED DATA FROM YOUR DEVICE.  DO NOT ACCESS ANY OTHER MENUS IN THE ANDROID RECOVERY MENU AS IT MAY BRICK YOUR DEVICE.  The information in this post is provided to assist in troubleshooting. Perform work at your own risk. If you do not feel comfortable performing the work, please contact us or your local service center. Be aware that ETC and its Affiliates are not responsible for any damage or injury caused by service of our products by anyone other than us or our authorized service providers, and such damage is excluded from the product’s warranty.

Power up or restart the device while holding the volume up button.  Continue holding until the Android recovery menu comes up. 

Use the volume buttons for navigation and the power button to select "Wipe data/factory reset"

Select "Factory data reset" in the following screen.

Look at the bottom left of the screen and wait until it says "Data wipe complete."

Select "Reboot system now."