Skip to main content
Electronic Theatre Controls Inc

Configuring F-Drive R12 via Net3 Concert

Issue

As of Concert 4.1.0, while RDM can be used to set a starting address for an F-Drive R12 or W1, other configuration data cannot be accessed and the device will not fully sync. A configuration must be created, then exported to the MicroSD card which is kept on the control card of the device with the filename rackConfig.cfg. Other config titles will not be recognized.

Explanation of Issue

In order to use an SD card to configure these drivers you will need Net3 Concert v4.1.0, which can be downloaded here.

RDM configuration of F-Drive devices is not yet fully supported.

 

  • Was this article helpful?