The fixture has PEM standoffs on each side of the yoke supporting the tilt bearing.
Rough handling or overtightening the screws when servicing can cause the standoffs to shear off the plate.
|
THIS DAMAGE DOES NOT CREATE A SAFETY HAZARD |
Repair may be needed if the tilt homing sensor is affected.
|
To prevent this situation, do not torque the cap screws to more than 15 in/lb.
|
If you have this damage on a unit, Kit #80430136 has parts and instructions for replacing the PEM Standoff bracket.
|
ETC and High End Systems no longer repairs or stocks parts for this fixture. If your fixture needs repair or you need parts to do a repair, then contact LightParts at https://www.lightparts.com/ or +1 512.873.7106
|