UPLD Appears on Display of Technobeam

Symptoms/Issue

Display reads UPLD

The unit will not home when powered on and the display show UPLD. The unit is stuck in upload mode and needs software installed

Connect the problem fixture to a working fixture of the same type via DMX cable.
Power on both fixtures.
After homing go into the Mode menu of the working fixture, look for xld, hit the enter button
The working fixture is now cross loading software to the problem fixture.
If the cross load is successful the problem fixture will home
It may take several attempts to cross load before the problem fixture takes the software.
If the problem fixture does not take the cross load then the logic board will need to be repaired.