Explanation ArcSystem fixtures, when powered on, may flash to full briefly. This is not an indication of a problem, it is a known behavior. The fixtures do not need to be powered off to achieve comple...Explanation ArcSystem fixtures, when powered on, may flash to full briefly. This is not an indication of a problem, it is a known behavior. The fixtures do not need to be powered off to achieve completely dark output and will dim fully to 0%.
It does not show up when scanning for TX-1s in the commissioning software and does not transmit DMX data to fixtures. All LED indicators on a TX-1, with the exception of Power, are driven by the Jenni...It does not show up when scanning for TX-1s in the commissioning software and does not transmit DMX data to fixtures. All LED indicators on a TX-1, with the exception of Power, are driven by the Jennic module on the main circuit board. If the Jennic module is faulty or not fully seated on the main board, it will not function and the only LED indicator lit will be Power. After powering it off, remove the lid of the TX-1 by unscrewing the two screws on its face.
When powered on, my newly installed ArcLamp Driver does not turn my ArcLamps on to full. By default, an ArcLamp Driver with power should push all ArcLamps connected to it to full. If the ArcLamps flas...When powered on, my newly installed ArcLamp Driver does not turn my ArcLamps on to full. By default, an ArcLamp Driver with power should push all ArcLamps connected to it to full. If the ArcLamps flash on and then immediately off or do not come on at all it is likely that your ArcLamp Driver has been pre-configured. Check the LED indicator lights on the driver first to see if Power and the appropriate Channel lights are on and static.
