Skip to main content
Electronic Theatre Controls Inc

Clearing Echoflex Controllers

Topic

How to clear Echoflex controllers to a default state using the [Clear]  button located on the controller. 

Procedure

The [Clear] button can be used to reset the controller either to its pre-commissioned state or to its factory default state.

To reset to pre-commissioned state:

  1. Press and hold the [Clear] button until the red Power and green Learn LEDs start blinking.
  2. Release the [Clear] button. The Power LED blink codes indicate the type and count of devices linked at pre-commissioning.

To reset to factory default state:

  1. Press and hold the [Clear] button until the red Power and green Learn LEDs start blinking
  2. Continue to hold for 15 seconds, until the LEDs stay on solid.
  3. Release the [Clear] button. The Power LED will be solid red to indicate factory default state.

Video Walkthrough

  • Was this article helpful?