Where do I land the ground on an Interconnect Cable in an auxiliary Paradigm DRd?

Question

I'm using a DRd12AX12 rack and noticed the Rack 2 end of the Interconnect Cable has a ground wire with a ring terminal attached. Where do I land this wire?

Answer

The easiest place to do this is by removing one of the four screws holding the right IO to the rack, insert the screw through the ring terminal and re-screw it back into place.

NOTE: Be sure that the side of the interconnect cable that has the ground ring terminal on it is in Rack 2.  This is the side of the rack that does not have the architectural processor.