Skip to main content
Electronic Theatre Controls Inc

How to disable gestures for Paradigm touchscreens in ControlDesigner

Question:

How do I disable the gestures for Paradigm touchscreens in ControlDesigner?

You cannot disable any gestures on the hardware itself. These instructions only apply to ControlDesigner 3.0.0 or higher, and only for P-TS7 or P-TS18 rev2 hardware.

For the whole configuration:

  1. Open your touchscreen .lcdconf in ControlDesigner
  2. Selection top-level of the config in the Object Browser
  3. In the Property Editor change "Page Change Gestures" from Yes to No
    cdtouchscreengestures-1.PNG
  4. Save your config and upload to the Paradigm system

For a single page:

  1. Open your touchscreen .lcdconf in ControlDesigner
  2. Select the page you want to remove gestures from
  3. In the Action Editor choose the Gesture type you want to remove
    cdtouchscreengestures-2.png
  4. Click the red X to remove the action from that gesture type
    cdtouchscreengestures-3.png
  5. Save your config and upload to the Paradigm system

For a popup:

  1. Open your toucshcreen .lcdconf in ControlDesigner
  2. Select the popup you want to remove gestures from
  3. In the Property Editor change "Hide Gestures" from Yes to No
    cdtouchscreengestures-4.png
  4. Save your config and upload to the Paradigm system

 

  • Was this article helpful?