Skip to main content
Electronic Theatre Controls Inc

Emphasis: Setting Face-panel Type


The information in this post is provided to assist in troubleshooting. Perform work at your own risk. ENSURE ANY POWER FROM DEVICES HAS BEEN DISCONNECTED BEFORE SERVICING ANY EQUIPMENT. If you do not feel comfortable performing the work, please contact us or your local service center. Be aware that ETC and its Affiliates are not responsible for any damage or injury caused by service of our products by anyone other than us or our authorized service providers, and such damage is excluded from the product’s warranty.

You must set the type of face-panel you have in your system to have the correct monitor outputs.

Setting Face-panel Type

  • Launch Emphasis
  • Go to Visualization, Emphasis Mode
  • Click on Setup
  • Click on Face-panel Type
  • Choose the face-panel that will be connected to the system
  • Click OK
  • Close Emphasis
  • Relaunch Emphasis for the changes to take effect

This setting will affect the CRT displays of all face-panels connected to the system.

  • Was this article helpful?