Which ETC Lights are Self-Terminated
Automatically Self-Terminated
The following fixtures self-terminate when there is nothing connected to their DMX thru, and do not require additional terminators at the end of the DMX line.
- All Series 3 S4 LED fixtures
- All Series 2 S4 LED fixtures
- All Series 1 S4 LED fixtures
- All fos/4 family fixtures
- D22 Portable
- D40 (indoor only)
- D60 (indoor only)
- Desire Fresnel
Manually Self-Terminated
The following fixtures have a termination switch that must be set to "on" only when the fixtures is installed at the end of a DMX line.
- D22 Canopy DMX fixture
- Irideon WLZ Canopy DMX fixture
- Irideon FPZ Canopy DMX fixture
- D40 XTI (switch is located on the XTI term board)
- D60 XTI (switch is located on the XTI term board)
Not Self-Terminated
The following fixtures are not self-terminated and require a 120-ohm resistor at end of line for DMX Termination.
- D40XT
- D60X
- Arcsystem fixtures (all)
- BluesSystem power supplies
- Relevé
- Selador fixtures
- All Source 4WRDs
- All ColorSource V Fixtures
- All ColorSource Fixtures
- Track Mount Fixtures (terminate at the end of the track)
- Navis RGBW and Chroma (termination required for CAN bus protocol. ETC Part Number: N4086 - 120Ω RJ45 terminator)