Set Levels Locally at Sensor CEM Classic

Question

How do I set levels from my Sensor CEM Classic?

How do I control my dimmers locally from my Sensor CEM Classic?

Steps to Solution

You can set levels using the keypad and screen on your CEM to locally control the dimmers in your Sensor Classic rack. This will allow you to test the output from the CEM. From the home screen, use the keypad to choose a selection of dimmer numbers and set them at the levels you want. You will first choose the numbers you want, then choose the levels that you want them at:

Range Selection

1. # thru # = All in range (if dimmer doubled 1A, 1B, 2A, 2B, 3A, 3B, 4A, 4B, 5A, 5B, 6A)
   1. Ex: 1 thru 6
2. # thru # next = All in range including B-side of last in range if dimmer doubled (ex: 1A-6B)
   1. Ex: 1 thru 6 next
3. # last thru # last = All A-side dimmer range for dimmer doubled dimmers
   1. Ex: 1 last thru 6 last
4. # next thru # next = All A-side dimmer range for dimmer doubled dimmers
   1. Ex: 1 next thru 6 next

Activating Level of selection

1. at [Clear] enter = Not Set = Release
2. at 100 enter= FL = 100%
3. at 0 enter = Hold at 0%

Full example: 1 thru 6 at 100 = dimmers 1-6 at full/100%