Skip to main content

 

Electronic Theatre Controls Inc

Changing 575 Spot From Number Mode to Channel Mode

Changing from fixture number mode to DMX starting channel mode

Fixture Number Mode

To address the studio spot by fixture number, complete the following procedure:

  1. Apply power to the fixture.
  2. After the fixture homes, observe the display on the front of the fixture.  Initially, it will display SPOT, the software version Vxxx, and then the fixture number F 01.
  3. Press and hold <MENU> until the display changes to​​​​​​​ ADDR. Press <ENTER>  to manipulate the address field.
  4. Using the up and down keys, set the fixture number from F 01 to F 21. The display will flash when it is moved from the stored value.
  5. Press <ENTER> to store the fixture number. The display will stop flashing.  Note: If <ENTER> is not pressed, the unit will not store the fixture number.
  6. Press <MENU> to exit the menu.

DMX STARTING CHANNEL MODE

To address studio spot by DMX starting channel, complete the following procedure:

  1. Press and hold <MENU> until the display changes  to ADDR.
  2. Using the up and down keys, scroll to SET and press <ENTER>.
  3. Using the up and down keys, scroll to CHNL and press <ENTER>.
  4. Using the up and down keys, scroll to DMX and press <ENTER>. Press <MENU> twice to move back up menu levels to ADDR. Press <ENTER> to address the fixture.
  5. Using the up and down keys, set a starting channel from C 001 to C 489.  The display will flash when it is moved from the stored value.
  6. Press <ENTER> to store the desired starting channel.  The display will stop flashing.  Note: If <ENTER> is not pressed, the unit will not store the starting channel.
  7. Press and hold <MENU> to exit menu.

 

  • Was this article helpful?