How to Configure Circuits on Legacy Unison Processor

You can configure the following for each circuit in a Legacy Unison rack via the processor:

• Module type
• Load type
• DMX address
• **Depending on the module/load type you choose, you may get an additional configuration option
  • Ex: if you choose 2 wire fluorescent for load type, you get a ballast type option

Steps to Configure Circuits

1. Press and hold hidden Unison Menu Activate Button above the Unison logo on Unison Processor. Menu will change from "System OK" or "Dimmer Errors" to [STAT].
2. Press the Arrow Down button until processor displays [CONFG].
3. Press Enter to navigate the 'ckt' option.
4. Press the Up/Down Arrow buttons to select the circuit number.
   1. Circuits go by lugs in the rack.
5. Press Enter to navigate to the 'module' page.
6. Press the Up/Down Arrow buttons to select the module type.
7. Press Enter to navigate to the 'load type' page.
8. Press the Up/Down Arrow buttons to select the load type.
9. Press Enter to navigate to the 'DMX' page.
10. Press the Up/Down Arrow buttons to select the DMX address.
11. Repeat for any additional configuration options.
12. Press the Up/Down Arrow buttons to select the sequence preference.
13. Press Enter, you will be prompted to save changes.
    1. If you want to configure another circuit, press the Exit button until you are back on the 'ckt' option page and use the Up/Down Arrow buttons to select another circuit.
    2. If you are satisfied with your changes, press the Up arrow button to choose [YES] and press Enter.

Video Walkthrough