Replacing Screws on Haptic Display with Nylon Screws on Apex Class Hardware

• Open up control panel of console
  • Opening the Control Panel on Eos Apex Consoles for Service

• Identify one of the Haptic displays
  • All Apex Consoles have a 6.3" Display attached to the facepanel keyboard
  • Apex 5 has one 5" Haptic Display attached the the single bank of motorized faders
  • Apex 10 has two 5" Haptic Displays
  • Apex 20 has four 5" Haptic Displays

• Begin by selecting one display to work on
• Replace the bottom left screw
  • Only use a #1 Phillips screw driver
  • Only hand tighten screw, do not over tighten
    • Over-tightening will strip the screw and cause it to fail

Only replace one screw at a time. Do not remove multiple silver screws at once.

• Replace the top right screw
  • Only use a screw driver
  • Only hand tighten screw, do not over tighten

• Replace the top left screw
  • Only use a screw driver
  • Only hand tighten screw, do not over tighten

• Replace the bottom right screw
  • Only use a screw driver
  • Only hand tighten screw, do not over tighten