Skip to main content
Electronic Theatre Controls Inc

ArcSystem RDM Fixtures Lose Settings / Some Cells Stuck On

Symptoms/Issue

After a power cycle, ArcSystem RDM fixtures lose their settings and return to factory defaults (DMX address 1, single cell mode, minimum level 99%). This may result in one or all cells being stuck on. This is a bug present in ArcSystem RDM 1.0.0 and 1.0.1. Updating your fixtures via Updaterator to 1.0.2 or higher will resolve this problem. If updating is not possible, using Net3 Concert to reset the fixtures to defaults will temporarily resolve the problem until the fixtures are power cycled again.