Skip to main content

 

Electronic Theatre Controls Inc

Clear Overtemp, Airflow, and other Sticky Errors On The Sensor CEM

Several of the errors that are considered to be critical to the well-being of the Sensor rack continue to display after error status is no longer present.  These are referred to informally as "sticky" errors.  Sticky errors became a feature of the software in version 3.0 and greater.  This is an intentional function of the CEM--it insures that the user acknowledges that a critical error condition was present at some point.

To clear "sticky" errors, hold the [Clear] button down until all error messages are cleared and the second line of the LCD display reads "System OK".  This should occur within a couple seconds. 

If error messages remain after holding clear for several seconds, you may have an active fault.  Call ETC Technical Services for more specific instructions.

  • Was this article helpful?